Please select a state in the header.

Cover width: 825mm Total Width 877mm

Number of ribs - 1 underlap, 2 overlap, 33 internal 

Make Your Colorbond Roofing Last a Lifetime with These Tips

In an ideal scenario, when you purchase metal roofing materials online and have these installed in your home, they should last a lifetime.But despite the many benefits offered by Colorbond roofing, there are some property owners who have encountered problems with their roofs early on. In order to avoid these problems and have a roof that is both beautiful and functional (and will be sure to last a lifetime), here are some helpful tips that you can follow during installation. Standard drip edge If you are going to install a metal roof for a standard drip edge, start out by folding the roofing sheet and then cutting and folding the standing seam panel over the drip edge. Make sure you cover the eaves and gable ends. After this, you can install the metal shingles on the gable drip edge. Layover applications If the roof is going to be laid on a flat layer of existing roofing, use a C-D edge trim. This will allow you to hide the drip edge and other exposed edges of the current roof. Standard valley Using hand tongs, create valleys from roof pans by refolding its male and female legs. After that, crease the valley using a site break. Remember to install the drip edges and ridge caps first. After that, valley fit and then attach the cleats. The bottom portion should be folded around the drip edge while the roofing pans are hemmed into the valley hems. Trims In order to create a smooth transition at points where the ridge caps meet on gable dormers, create a bow-tie cleat. If you are going to need a vented ridge cap, make sure that it is installed before the pans. This makes the task easier for you and helps you avoid scratching the pans. On the other hand, if you need to install a sidewall flashing, you will need to fold the pan's edge by 90 degrees. Apply the siding over a perpendicular fold. You may also cut and install a counter flashing detail if working near a wall makes the installation of sidewall flashing difficult. For end-walls and chimney flashings, you can bend the roofing pan up the wall and then unfold the ribs. After that, you can seal these against your home. For skylight flashing, you will need to fabricate a sidewall flashing into roof pans. However, you have to stop the pans a few centimetres over the skylight. You will also need to install a cleat on butyl so that the head flashing can extend beyond the edge of the skylight toward the roof pan. The upper portion of the head flashing is then hemmed.